Short answer: Don't roll it on the table: the cloth, the taper and the joint make a straight cue wobble, and a bent cue can roll flat. To check if a pool cue is straight, sight down it like a rifle barrel while turning it a full circle, each half, then joined.
By Andy Gibson · Updated 17 October 2026
Why does rolling a cue on a pool table give the wrong answer?
Rolling tests how round the cue is and how flat the table is, not how straight the cue is. Four things get in the way:
- The cloth. Wear, nap and small variations in the cloth make even a straight cue wobble as it rolls.
- The taper. A modern cue has a thicker butt and a gradual taper to the tip. That shape rocks when it rolls, even when the cue is true, as cue maker John Parris points out.
- The butt. Many snooker cues have a flat (a chamfer) on the butt, which Riley notes makes rolling them in the usual way impossible.
- The joint. On a two-piece cue, a wobble on the roll more often shows a joint that isn't seated than a bent shaft (Dr Dave Alciatore's cue care FAQ).
It also works the other way. A bent cue can roll flat, so a smooth roll doesn't prove anything either.

How do you check if a pool cue is straight?
Sight it. Cue makers and repairers recommend the same method:
- Split the cue. Unscrew a two-piece or 3/4 cue and check the shaft first, then the butt.
- Hold it at eye level. Hold the butt end near your eye with the tip pointing away and slightly down.
- Close one eye and sight down it. Look along the cue from the butt to the tip, as if you were sighting a rifle.
- Turn it a full circle. Rotate the cue slowly through 360° while you watch the tip. A straight cue stays on the same line. A warped one appears to swing to one side as you turn it.
- Join it and check again. If both halves sight straight but the joined cue doesn't, the joint is the likely problem, not the wood.

Cue repairers go one step further and spin the cue on a lathe with a dial gauge, but sighting is the check you can do anywhere, including in the shop before you buy.
How much warp is too much?
No cue maker publishes a tolerance in millimetres. Timber cues move a little over their life, and a small amount of warp is normal.
A useful rule: if the tip stays on line as you turn the cue, play with it. If you have a slight bend, always hold the cue in the same rotation, so the bend stays in the same plane on every shot (Dr Dave Alciatore). If the tip clearly swings as you turn the cue, have it looked at or replace the shaft.
What makes a cue warp?
- Moisture. A cue is a long, thin piece of wood, and moisture is one of the main causes of warping (Dr Dave Alciatore). Wiping a shaft with a wet cloth adds to it.
- Heat and big swings in temperature. McDermott warns that extreme temperature or humidity causes expansion that can warp the cue and damage the finish. A car parked in the sun is the most common culprit, and a cold, damp car is no better.
- Leaning. A cue left leaning against a wall or in a corner can take on a bend over time.
- Sanding. Sandpaper and abrasive pads strip the sealer, which lets moisture into the wood.
How should you store a pool or snooker cue?
- Keep it in a case. A hard case protects better than a soft sleeve, and a case stored upright is better than one lying down (Dr Dave Alciatore).
- Or use a rack that holds it straight. A wall rack or floor stand keeps the cue upright and supported. McDermott suggests mounting wall racks on an inside wall, away from the temperature changes of an outside wall.
- Keep the room steady. McDermott recommends about 21°C and 40–50% humidity. Exact numbers matter less than avoiding big swings: away from heaters, air-conditioner vents, direct sun and garages.
- Never leave it in the car. Not in summer, and not overnight in winter either.
- Wipe it after you play. A dry cloth after each session removes chalk and hand oils without adding moisture. For ash snooker cues, cue makers recommend a little raw linseed oil a couple of times a year; don't use oil on maple pool shafts.
Choose your option
Choose your option
Choose your option
Can a warped cue be straightened?
Sometimes, but rarely for good. A cue with a slight bend can sometimes be eased back into shape; a worse one usually needs a new shaft (Dr Dave Alciatore). Repairers report that straightened shafts often move back, and bending a shaft by hand can snap it.
Check the warranty before anything else. Several makers cover warping, but damage from extreme heat or humidity is usually excluded, as in McDermott's warranty.
Which cue materials resist warping?
Every timber cue can move, ash and maple alike, and cue makers don't agree on which of the two is more stable. Wood selection, seasoning and care matter more than the species.
Carbon fibre and carbon composite shafts take wood out of the equation. Makers back that with warranties: Predator covers its carbon REVO shafts against warping for life.
| Shaft material | Warping | Example in our range |
|---|---|---|
| Ash | Can move with moisture and heat; care and storage matter most | Barracuda Gold Medal |
| Maple | Same as ash | Maple cues |
| Graphite | Moulded composite, no wood grain | Grafex Supreme |
| Carbon fibre / carbon composite | No wood to absorb moisture; makers warrant against warping | Grafex Gladiator, Powerglide Emanate |
Emanate - 2-Piece Carbon Composite Cue
Choose your option
Supreme - 2-Piece Multi Weight Graphite Cue
Choose your option
Gold Medal - 2-Piece High Grade Ash Cue
Choose your option
See the full carbon fibre, graphite and ash ranges.
Frequently asked questions
Is rolling a cue on the table a good test?
No. The cloth, the cue's taper, the flat on a snooker butt and the joint can all make a straight cue wobble, and a bent cue can still roll flat.
How can I tell if my pool cue is warped?
Sight down it from the butt with one eye closed while turning it a full circle. If the tip appears to swing to one side, it's warped.
Is a slightly warped cue still playable?
Usually. Hold it in the same rotation every shot so the bend stays in one plane. If the tip clearly swings when you sight it, replace the shaft.
Can I leave my cue in the car?
No. Heat and big temperature and humidity swings are among the main causes of warping.
Should a cue be stored standing up or lying down?
Upright in a rack or a case, or lying flat with full support. Never leaning against a wall or in a corner.
Do carbon fibre cues warp?
Carbon shafts have no wood to absorb moisture, and makers such as Predator warrant them against warping.
Can a warped cue be fixed?
A slight bend can sometimes be eased out, but it often returns. A replacement shaft is the reliable fix.

